Width: 12 mm
Depth: 40 mm
Button Ø: 4.5 mm
Rubber: 75 mm x 0.3 mm
Hexagon socket screws: M3 x 12 mm
Cable length: 570 mm
Assignment:
Button A : green + red (from below)
Button B : green + brown
Green = input signal
Scope of delivery: 1 piece push button 1 x rubber 2 x screws
Notes: NOT for currents over 0.05 amps. At 12 volts max. 0.6 watts!
Caution during assembly!!! The push-button unit is only inserted into the housing and is held in place by pressure against the housing wall. If the push-buttons are actuated in an unassembled state, the entire push-button unit may be pushed out of the housing, which may then also cause the attached push-button rubbers to fall into the housing. This does not mean that the switch is broken, but only that it has to be returned to its original condition.
To prevent the push-buttons from slipping out, hold the push-button unit between your thumb and index finger when pressing it.
Anbauanleitung/Sicherheitshinweise
Anbauanleitung/Sicherheitshinweise Mounting and safety instructions
Anbauanleitung/Sicherheitshinweise